MSL-101E ELECTRONIC LOCK OPERATING INSTRUCTIONS
Factory Default Code- User Code: 0 - 0 - 0 - 0
- Enter
- User Code - 
- Turn the handle clockwise while the LED is GREEN.
- If an invalid code is entered three consecutive times this will put hte lock in a one minute lock out state. You will not get any response from the keypad during this period.
- The override code is used only to place the "User Code" back to the factory default.
- The Override code is factory set to 7 - 7 - 7 - 7 - 7 - 7
- Enter - Override Code -
- The "User Code" is now set back to the factory default.
- We highly recommend that you change the factory set override code.
- Important: Please keep the door opened and place in the locked position when changing the user code. AFter changing the user code please test the new code several times.
- The User & Master Code can be set to a 1 to 12 digit code.
- Enter - existing code -
- Enter the new code then press
- The LED is now ORANGE for 10 seconds.
- Re-enter the new code then press
- If a mistake is made wait 15 seconds and repeat steps 1-5.
- The time delay can be set for a period of 1-99 minutes. Delays opening and programming.
- Enter - Master Code -
- The LED is now orange for 10 seconds.
- Enter - (01-99) - - (01-99) -
- or will initiate the Time Delay.
- The LED will signal once every 2 seconds indicating that the lock is in the delay period.
- After the time delay period, a 2 minute window is given to enter code.
- The LED will signal twice every second during the two minute window.
- Enter - Master Code -
- The "Set" LED is now orange for 20 seconds.
- Enter - 00 - - 00 -
Low battery warning
- The LED light turns RED during an opening indicates that the battery is low and needs immediate replacement
- Uses one 9-volt alkaline battery
If batteries are depleted and will not allow lock to open, simply follow the instructions below. Lock contains a non-volatile memory, even with batteries removed the lock will retain all programming.
- Locate the battery cover on the bottom edge of the keypad and remove the cover by pulling on the tab.
- Carefully remove the 9-volt battery from the compartment.
CAUTION: Hold onto battery connector to avoid pulling wires out of housing. - Reinsert the new battery, do not force the battery into the compartment.